山东不锈钢雕塑抛光技术解读

1.与山东不锈钢制造厂家一起商定需要的表面加工，最好准备一个样品，作为今后批量生产的标准。With the Shandong stainless steel manufacturers agreed to the needs of the surface processing, it is best to prepare a sample, as the future of mass production standards.

2.大面积使用时（如复合板，必须保证所用的基底卷板或卷材采用的是同一批次。The use of large area (such as composite board, you must ensure that the basement membrane coil or is used in the same batch.

3.山东不锈钢雕塑专家认为，在许多建筑应用中，如：电梯内部，尽管手印可以擦掉，但很不美观。如果选用布纹表面，就不那么明显了。在这些敏感的地方一定不能使用镜面不锈钢。Shandong stainless steel sculpture experts believe that in many construction applications, such as: inside the elevator, although fingerprints can be erased, but very beautiful. If the grain surface is not so obvious. Mirror stainless steel must not be used in these sensitive areas.

4.选择表面加工时应考虑到制作工艺，例如：为了除去焊珠，可能要对焊缝进行修磨，而且还要恢复原有的表面加工。花纹板很难甚至无法满足这一要求。Selection of surface processing should take into account the production process, such as: in order to remove the welding bead, it may be to repair the welding seam, but also to restore the original surface processing. Pattern plate is difficult to meet the requirements.

5.对于有些表面加工、修磨或抛光的纹路是有方向性的，被称为单向的。如果使用时使这种纹路垂直而不是水平，污物就不易附着在上面，而且容易清洗。For some surface processing, grinding or polishing of the lines are directional, known as one-way. If it is used to make the grain vertical rather than horizontal, dirt is not easy to attach to it, and it is easy to clean.

6.山东不锈钢雕塑厂家认为，无论采用哪种精加工都需要增加工艺步骤，因此要增加费用，所以，选择表面加工时要慎重。因此，建筑师、设计人员和制造厂家等有关人员需要对不锈钢的表面加工有所了解。通过彼此之间的友好合作和相互交流，一定会获得所期望的效果。Shandong stainless steel sculpture manufacturers believe that no matter what kind of finishing are required to increase the process steps, so to increase the cost, therefore, the choice of surface processing should be careful. Therefore, architects, designers and manufacturers and other relevant personnel need to understand the surface of stainless steel. Through friendly cooperation and mutual exchange, the desired effect will be obtained.

7.根据山东不锈钢雕塑专家的经验，我们不建议使用氧化铝作磨料，除非在使用过程中十分小心。最好是使用碳化 硅磨料。According to the experience of Shandong stainless steel sculpture experts, we do not recommend the use of alumina as abrasive, unless very carefully in the course of use. It is best to use silicon carbide abrasive.